Skip to content
STaSIS Assembly Instructions for Rotor Hats

STaSIS Assembly Instructions for Rotor Hats

All information contained in this article are the property of STaSIS engineering and are provided as a courtesy to AlconKits customers.  If you do not feel comfortable with these instructions we would encourage you to contact one of our service partners.  You can bring in your vehicle or send in the rotors and hardware for service.  See our lists of service providers nearest you here:  AlconKits Installers and Service Providers.

 

Tools Required:

  • Vice
  • In-lb Torque Wrench
  • 5/16” socket
  • 7/16” open end wrench or socket

Torque Specs for NAS Nuts: 120 in-lbs

 

Special Notes: Note orientation of mounting hardware in figure 1. Install Bellville washers on every other bolt, and note washer orientation as seen in figure 2.

 

FIGURE 1.

 

Refer to the to the diagrams below. Note the orientation of the Belleville washers.  They are located on the Bobbin.  The Belleville washers are designed to provide spring force against the rotor to prevent rattling of the rotor and float capability.

 

 

FIGURE 2.

 

Note the parts used for your rotor installation.

1. Insert bolts (1) into Bobbins (2)

2. Install Belleville washers (3) onto bobbins (2) as shown in figure 1.

3. Insert Bolts/Bobbin/Washer assembly into the rotor as shown in figure 2.

4. Install hardened washers (4) onto bolts on the outside of the rotor

5. Place hat over bolts.  The hardened washers may create a gap.

6. Install jet nuts onto bolts over hats and tighten loosely by hand.

7. Torque jet nuts in a star pattern to final torque.  (120-in-lbs).

Previous article Assembly procedure for Alcon full floating bobbin drive discs
Next article Alcon Road Kit Bobbin Assembly Instructions. Wave spring style